5-12
Supplement
It will return to ARMS setting screen (2/4) without
changing the settings when you press the
POSITION (
◄
) key (CANCEL).
Digits of the setting can be changed by pressing
the [FAST] key.
4
Press the [3] key (MARK SIZE).
MARK SIZE setting screen is displayed.
5
Press the POSITION (
▲▼
) key and increase or decrease the
setting value.
Supplement
It will return to ARMS setting screen (2/4) without
changing the settings when you press the
POSITION (
◄
) key (CANCEL).
6
Confirm the settings and press the [ENTER] key (SET).
Setting will be set, and it will return to ARMS setting screen (2/4).
7
Press the [MENU] key.
It will return to default screen.
Setting Mark Distance
Mark distance is set so it will not perform detection of the location where the registration marks are not present.
This allows to scan the registration marks faster, and also prevents malfunction by the dirty media.
You can write a comment (TYPE1), or write the cut data (TYPE2) in the area that the registration mark is not
detected.
Reference
Specify the distance between the registration marks in the direction of media movement for X, and the distance between the registration marks
in the direction of the tool block movement for Y. (See below).
MARK TYPE 1
Set this distance
for MARK
DISTANCE X
Feed direction of media
MARK TYPE 2
Set this distance for
MARK DISTANCE Y
Set this distance for
MARK DISTANCE Y
Set this distance
for MARK
DISTANCE X
Feed direction of media
Detection is started from the position of the registration mark size before the specified distance.
Skipping of the distance between the registration mark will not be performed until next registration mark is found when the mark distance is set
to 0 mm.
Value of Y is ignored if it is 2POINTS.
Enter value smaller than the length of the media for the MARK DISTANCE X. The media gets dropped if it is larger.
l
l
l
l
l
To Next Page
Loading...
