7-7
Setting the TOOL UP HEIGHT
Tip of the tool might touch the media when the blade is moved in normal tool up status when using a thick
media such as sand blast rubber. TOOL UP HEIGHT is set to raise the tool higher than normal tool up
status for these cases.
Leave the TOOL UP HEIGHT to default value (0) when using the media with normal thickness.
Height of normal tool up status
Tool higher than normal
tool up status with TOOL
UP HEIGHT set
Height set with the TOOL UP HEIGHT
Next page
1
Press the [MENU] key.
MENU screen is displayed.
2
Press the [1] key (TOOL).
TOOLS SETTING screen (1/3) is displayed.
3
Press the POSITION (
▲
) key.
TOOLS SETTING screen (3/3) is displayed.
Supplement
Setting range is between 0.0 and 5.0 mm.
It will return to TOOL setup screen (3/3) without
changing the settings when you press the
POSITION (
◄
) key (CANCEL).
l
l
4
Press the [4] key (TOOL UP HEIGHT).
TOOL UP HEIGHT setting screen is displayed.
To Next Page
Loading...
