5-2 5-3
Supplement
Left figure is for 4POINTS. Number of the
registration mark will be different for the
2POINTS and 3 POINTS, but the shape of the
registration mark will be same.
See "Setting Shape (Pattern) of Registration
Mark"
P.5-9
to change the shape (pattern)
of the registration mark.
See "Setting Mark Distance"
P.5-12
for
setting MARK DISTANCE.
l
l
l
MARK TYPE 2
MARK TYPE 2 is used when you would like to use as much area
possible on the media as cutting area. The registration mark is
inside the cutting area, so set the MARK DISTANCE so plotted
image will not be mistaken as a registration mark. Also, you can not
cut close to the registration mark.
MARK TYPE 2
Feed direction of media
Supplement
Create the registration mark as a plotting data with the application software. Registration marks generated by the application software cannot
be used.
Create the registration mark in accordance with following conditions.
· Thickness of the line is between 0.3 and 1.0 mm.
· Size of the registration mark is between 5 and 20 mm (see "Setting Registration Mark Size"
P.5-11
).
· Use pattern 1 or pattern 2 for the shape of the registration mark.
· Create the registration mark with single line, and specify the thickness of line to necessary thickness. Double line cannot be used.
l
l
Scan Range Necessary to Detect the Registration Mark
The range of tool carriage and media movement needed to scan the registration mark is as following.
MARK TYPE 1 MARK TYPE 2
Registration scanning area
a
a = 6 mm
Feed direction of media
Registration scanning area
a = 6 mm
a
a
a
a
a
Feed direction of media
Feed direction of media
Feed direction of media
MARK TYPE 1 MARK TYPE 2
a = 6 mm a = 6 mm
a
a
a
a
Registration scanning area Registration scanning area
For 3POINTS For 4POINTS
a
a
The area necessary to scan the registration mark when the mark distance is set is as following:
To Next Page
Loading...
