GRAPHTEC FC8600 SERIES - Positioning of the Media and the Registration Mark

5-4
5-5
MARK TYPE 1 MARK TYPE 2
Registration scanning area
a
a = 6 mm
Feed direction of media
Registration scanning area
a = 6 mm
a
a
a
a
a
Feed direction of media Feed direction of media Feed direction of media
MARK TYPE 1 MARK TYPE 2
a
a = 6 mm a = 6 mm
a
a
a
a
a
Registration scanning area Registration scanning area
For 3POINTS For 4POINTS
Supplement
See "Setting Shape (Pattern) of Registration Mark"
P.5-9
to change the shape (pattern) of the registration mark.
See "Setting Mark Distance"
P.5-12
for setting mark distance.
It may mistakenly detect as registration mark if there is anything else plotted within the registration scanning area. Adjust the "MARK
DISTANCE" so it can scan the registration mark correctly. (See "Setting Mark Distance"
P.5-12
)
Clean any dirt or foreign objects from the media. Any dirt or foreign object might be scanned mistakenly as registration mark.
Plot the registration mark in contrast easy to scan, such as black lines on white background. Adjust the scanning level of the sensor if you need
to use the colored or glossy media. (See "Adjusting the Sensor Level "
P.5-18
)
l
l
l
l
l
Positioning of the Media and the Registration Mark
Place the registration mark away from the edge of media to scan the registration mark.
Write the registration mark as following for the sheet media.
MARK TYPE 1
52
Leftmost
push roller
25
22 15
Rightmost
push roller
Feed direction of media
MARK TYPE 2
5225
Leftmost
push roller
Rightmost
push roller
22 15
Feed direction of media
Unit: mm
Write the registration mark with at least 110 mm from the end of media as shown below for the roll media.
MARK TYPE 1
110
Leftmost
push roller
20
22 15
Rightmost
push roller
Feed direction of media
MARK TYPE 2
Leftmost
push roller
Rightmost
push roller
11020
22 15
Feed direction of media
Unit: mm
6
6
6 6
6
6 6 6