GRAPHTEC FC8600 SERIES - Apparel (AP) Mode; Switching Apparel Mode

4-20
4
-
4-21
Apparel (AP) Mode
4
Apparel (AP) mode is a function to use the FC8600 in combination with CAD for apparel. This function
becomes enabled by turning on the apparel mode. Turn off this function for all other uses.
When the apparel mode is on, if the control command is not received within the specified time, it will be
considered as timeout, and media will be cross cut. It will also cross cut when the separator command is
received. Cross cut position will be "space rear" (item name: SPACE REAR) added behind the cut area. A
separator command for GP-GL and HP-GL can also be set.
Switching Apparel Mode
Next page
Operation
1
Press the [MENU] key.
MENU screen is displayed.
2
Press the [4] key (MEDIA).
MEDIA SETTING screen (1/3) is displayed.
3
Press the POSITION (
▼
) key.
POSITION
MEDIA SETTING screen (2/3) is displayed.
Supplement
It will return to MEDIA setting screen (2/3)
without changing the settings when you press the
POSITION (
◄
) key (CANCEL).
4
Press the [4] key (AP MODE).
AP MODE screen is displayed.