GRAPHTEC FC8600 SERIES - Selecting Tool Condition

2-24
2
-
2-25
Selecting Tool Condition
9
Tool conditions can be set in 8 settings from 1 to 8. Then, you can switch between 8 predefined different
setting for different media by switching the settings.
Operation
Supplement
Name of the media assigned in "Cutting Plotter
controller" is displayed as the CONDITION No.
name.
CONDITION No. can also be changed from
READY status. See "Changing CONDITION
No."
P.3-6
.
l
l
1
Press the [CONDITION] key in the default screen.
CONDITION setting screen (1/3) is displayed.
Supplement
It will return to CONDITION screen without
changing the settings when you press the
POSITION (
◄
) key (CANCEL).
2
Press the [1] key.
CONDITION No. selection screen is displayed.
3
Press the POSITION (
▲▼
) key and select the setting
(CONDITION No.).
POSITION
4
Confirm the setting and press the [ENTER] key (SET).
Setting will be set, and it will return to CONDITION screen (1/3).
5
Press the [CONDITION] key.
It will return to the default screen.