4-24
4
-
4-25
Panel Cutting
5
To prevent long skew, utilize partition length when cutting.
Supplement
When Partition Pastern is on, the machine will begin by dividing up partition length and continue cutting until one of the following data breaks
appears. When the first partitioned area cut is finished, the machine will move to the next area, and repeat this until all areas have been cut.
Data Breaks:
(1) No data sent for a few second after finishing cutting. (Time Out)
(2) A feed-related command is set. (GP-GL: F, FS commands, HP-GL: AF, AH, PG commands)
(3) HP-GL: SP0, NR, GP-GL: J0, SO.
(4) When commands from data breaks (2) and (3) appear, that command work will begin after the partition pastern cutting is finished.
Partition pastern cutting will continue for each piece of data when a data break is caused by a command, even if multiple pieces of data are
sent in before the cutting finishes (even when numerous pieces of partition pastern data are in the plotter buffer).
When partition pastern and auto media transfer are both turned on, the machine will ignore automatic media transfer length settings and
continue working with priority of partition length plus something minutes ago (with footprints).
When partition pastern is on, and registration marks will not be seen ignored, and copy, initial feed, and cutting area cannot be changed.
Partition pastern cannot be done when one file of data makes the buffer full. Make sure to always send in data lower than the buffer size
l
l
l
l
l
l
Reference
This setting will be saved even if the power is shut off.
Next page
Supplement
User name assigned in "Cutting Plotter Controller"
is displayed as the user name.
1
Press the [PAUSE/MENU] key.
MENU screen is displayed.
2
Press the [4] key (MEDIA).
MEDIA SETTING screen (1/3) is displayed.
3
Press the POSITION (
▲
) key
MEDIA SETTING screen (3/3) is displayed.
To Next Page
Loading...
