8-1
Chapter 8: Settings Regarding Cutting
Time
Time necessary for cutting depends on the speed to move the tool and
media, and efficiency of the operation.
It is best to cut slowly and carefully to cut precisely, but the speed is
required to enhance the operational efficiency. The setting needs to be
in good balance considering the characteristics of the media and tools,
and the contents of the cutting data.
This chapter describes the settings affecting the cutting time.
In addition to this chapter, there are setting affecting the cutting times
in following places.
P.2-24
Selecting Tool Condition
P.5-12
Setting Mark Distance
To Next Page
Loading...
