GRAPHTEC FC8600 SERIES - Perform Automatic Pre Feed When Cut Data Is Received

8-4
8
-
8-5
Perform Automatic Pre Feed When
Cut Data is Received
It is possible to feed and reverse the media automatically for specified amount when the plotter receives
the cutting data.
"Pre feeding" to prevent the shifting of media can be done automatically. Also, the media will be unrolled
from the roll before cutting when rolled media is to be used.
P.2-23
"Pre Feed of Media (Paper or Marking Film)"
P.8-6
"Perform Automatic Pre Feed When Media is Set (Initial Feed)"
P.8-7
"Setting Feed Speed for Pre Feed"
Supplement
The setting for AUTO PRE FEED when cutting data is received is maintained even if the power is turned off.
Setting of the AUTO PRE FEED length is not linked to the setting of the page length. Change the setting for the page length if the cutting
area is to be long.
l
l
Next page
Operation
1
Press the [MENU] key.
MENU screen is displayed.
2
Press the [4] key (MEDIA).
MEDIA SETTING screen (1/3) is displayed.
3
Press the [2] key (AUTO PRE FEED).
AUTO PRE FEED screen is displayed.
4
Press the [1] key.
AUTO PRE FEED setting screen is displayed.
2