GRAPHTEC FC8600 SERIES - Creating CUTTING PRO

13-20
13
-
13-2113-21
Creating CUTTING PRO
Create a test pattern to check the operation of the plotter.
CAUTION
Do not place your hand around the moving areas. The tool carriage will start moving, so there is a chance of injury. Tool carriage will start to move
immediately after selecting to plot the test pattern.
Next page
Operation
Supplement
See "Loading Media (Paper or Marking Film)"
P.2-6
for loading the media.
1
Set a media larger than A3 size.
Supplement
See "Attaching a Tool"
P.2-4
for setting the
pen tool.
2
Set the pen tool to the tool carriage and select the condition
where the pen tool is set.
3
Press the [MENU] key.
MENU screen is displayed.
4
Press the POSITION (
◄
) key (TEST).
POSITION
TEST menu screen (1/2) is displayed.
5
Press the POSITION (
▼
) key.
POSITION
TEST menu screen (2/2) is displayed.
6
Press the [1] key (CUTTING PRO).
CUTTING PRO start screen is displayed.
4