3-14 3-15
Cross Cut Manually
Cross cut at the tool carriage position.
It is possible to cut off the roll media at desired position by cross cutting after manually moving the media using
the POSITION (
▲▼
) key.
CAUTION
Do not place your hand where the blade might move. You may be injured.
1
Press the [CROSS CUT] key in the READY status.
CROSS CUT screen is displayed.
Supplement
It will return to default screen without cross cut by
pressing the [2] key (CANCEL).
2
Press the [1] key (CUT).
Media is cross cut.
To Next Page
Loading...
