GRAPHTEC FC8600 SERIES - When the Media Replacement Mode Is Disabled and Cross Cut Is Enabled

4-14
4-15
Second copy Fourth copy
First copy
Third copy
Origin point
Copy origin
point
Copy
space
Copy
space
First cut
Media is cross cut at this position.
7
Confirm the setting and press the POSITION (
◄
) key
(PREVIOUS).
POSITION
Copy space will be selected, and it will return to COPY MODE
screen.
8
Confirm the setting and press the [ENTER] key (SET).
The copy of the data restored in buffer starts once. When the data is not fully
copied, ”COPY MODE CHANGE MEDIA! “ appears.
9
Replace the media.
The plotter starts a copy immediately after replacing the media.
This operation's specified number of copies will be repeated.
In the case of suspension, press the POSITION (
◄
) key
(QUITCOPY).
POSITION
When the media replacement mode is disabled and cross cut is enabled
Cutting is repeated the specified number of times using the cutting data stored in the buffer memory, and
media is cross cut when the media shifts in the media feed direction.
Supplement
Cross cut is not performed in the case of front loading and sheet media.
When the mirror or rotation is set to on, the registration mark scan data cannot be copied.
l
l
Copy is performed as follows.
Supplement
Cutting data is stored even if the media is
exchanged. It can be copied as many times until
the buffer memory is cleared. It can be copied
again after exchanging the media by pressing
[COPY] key.
Supplement
"CANNOT COPY CUT AREA TOO SMALL!" is
displayed if the cutting area is smaller than the
copy data. Either expand the cutting area, or set
the media that is big enough to copy.
Cross
cut
space
Cross cut
space