GRAPHTEC FC8600 SERIES - For between Tool 1 and 3

14-10
14-11
14
Confirm the setting and press the POSITION (
◄
) key
(PREVIOUS).
POSITION
X AXIS ALIGNMENT is selected and return to the TOOL OFFSET
ADJ. screen.
15
Press the [4] key (Y).
Y AXIS ALIGNMENT setting screen is displayed.
16
Press the POSITION (
▲▼
) key to increase or decrease the
value to set the difference in Y axis direction measured in step
11.
POSITION
17
Confirm the setting and press the POSITION (
◄
) key
(PREVIOUS).
POSITION
Y AXIS ALIGNMENT is selected and return to the TOOL OFFSET
ADJ. screen.
18
Repeat steps 7 to 17 until there is no difference.
19
Confirm the distance and press the [ENTER] key (SET).
Setting will be set, and it will return to TOOLS SETTING screen (1/3).
20
Press the [MENU] key.
It will return to default screen.
For between tool 1 and 3
Position adjustment is performed by entering the compensation value if there is a difference between tool 1
(tool attached to the backward of the tool holder) and tool 3 (tool attached to the forward of the tool holder).
Next page
Operation
CAUTION
When pushing the tool holder with your fingers,
the blade tip may be protruding. Take care not to
cut your fingers.
1
Mount either the cutter plungers or the plotting pens on the tool
1 (backward of the tool holder) and turn on the power.
2
Press the [MENU] key in READY status.
MENU screen is displayed.