14-11
Next page
3
Press the [1] key (TOOL).
TOOLS SETTING screen (1/3) is displayed.
Supplement
It will return to TOOLS SETTING screen (1/3)
without changing the settings when you press the
POSITION (
◄
) key (CANCEL).
4
Press the [2] key (TOOL OFFSET ADJ.).
TOOL OFFSET ADJ. setting screen is displayed.
5
Press the [2] key (TEST PATTERN).
Tool position move screen is displayed.
Supplement
It will return to TOOL OFFSET ADJ. screen by
pressing the [4] key (CANCEL).
Speed of movement will become faster by
pressing the [FAST] key and POSITION key
simultaneously.
l
l
6
Press the POSITION (
▲▼◄►
) key to move the tool carriage to
the location to draw "+". Move at least 50 mm inside the cutting
are for both X and Y.
Supplement
Tool condition 1 will be used with tool 1.
7
Confirm the position of the tool and press the [ENTER] key.
Tool 1 will plot the "+". Screen prompting to change the tool is
displayed once the plotting is completed.
Supplement
Tool condition 3 will be used with tool 3.
8
Set the cutter plunger or plotting pen to the tool 3 (forward of the
tool holder) and press the [ENTER] key.
Tool 3 will plot the "+" and return to the TOOL OFFSET ADJ.
screen once the plotting is completed.
To Next Page
Loading...
