GRAPHTEC FC8600 SERIES - Contents of Operation from Menu Screen; Contents of Operation from CONDITION Key

2-18
2-19
Icon of the corresponding operation button is displayed in the screen to change the setting values.
Increase or decrease the setting
value using POSITION (
▲▼
) key.
Select the change unit by [FAST]
key.
Select the setting by
number keys (1, 2, 3, 4) or
POSITION (
▲▼◄►
) keys.
Example of screen to change the settings value
Contents of Operation from Menu Screen
MENU screen
Contents of the operation and settings that is displayed in MENU screen with [MENU] key is as following:
[1] (TOOL): Make the setting for the operation of the tool.
[2] (ARMS): Make the settings and operation to position the tool and media, such as automatic scanning of the
registration marks by the ARMS.
[3] (AREA): Make the settings for area, magnification, rotation, reverse, etc., of the cutting.
[4] (MEDIA): Make the setting of the condition for the media.
[
▲
] (I/F): Make the settings of the condition for the interfacing with the control computer.
[
▼
] (ADV): Make the settings of the conditions for the basic operation of the plotter, such as display language,
unit of the measurements, sensor, etc.
[
◄
] (TEST): Does the operation necessary for maintenance, such as self diagnostic test or printout of the
condition settings list.
MENU: It will close the MENU screen and return to default screen.
P.15-2
See the "Menu Tree" for list of the descriptions about each settings.
Contents of Operation from CONDITION Key
CONDITION screen (1-3)
Tool conditions are set in the setting screens displayed by the
[CONDITION]
key.
Up to 8 CONDITION settings can be saved with different settings in numbers 1 through 8.
CONDITION: It will clear the CONDITION screen and return to default screen.
P.15-2
See the "Menu Tree" for list of the descriptions about each settings.