GRAPHTEC FC8600 SERIES - Setting the Force

2-28
2-29
Setting the Force
Set the cutting force that is used in each of the condition numbers. (Setting range: 1 to 48)
Operation
1
Press the [CONDITION] key in the default screen.
CONDITION setting screen (1/3) is displayed.
Supplement
It will return to CONDITION screen (1/3) without
changing the settings when you press the [4] key
(CANCEL).
2
Press the [4] key (FORCE).
FORCE setting screen is displayed.
* Display may vary depending on the selected condition number.
Supplement
Guideline to set force
See "Setting the Tool Condition"
P.2-25
.
3
Press the POSITION (
◄►
) key and select the condition number
(CONDITION No.).
POSITION
4
Press the POSITION (
▲▼
) key and increase or decrease the
setting value.
POSITION
5
Confirm the setting and press the [ENTER] key (SET).
Setting will be set, and it will return to CONDITION screen (1/3).
6
Press the [CONDITION] key.
It will return to the default screen.