GRAPHTEC FC8600 SERIES - Setting Enlarge;Shrink Scale

4-8 4-9
Setting Enlarge/Shrink Scale
It can enlarge or shrink cutting.
The rate of enlargement or shrinkage of the cutting data can be changed by settings.
Supplement
Settings of the enlarge/shrink scale is maintained even if the power is turned off.
Operation
1
Press the [MENU] key.
MENU screen is displayed.
2
Press the [3] key (AREA).
AREA PARAMETERS setting screen (1/2) is displayed.
3
Press the [2] key (SCALE).
SCALE setting screen is displayed.
Supplement
Values that can be set are 1/8, 1/4, 1/2, 1, 2, 3, 4,
5, 6, 7, and 8 (multiplications).
4
Press the POSITION (
▲▼
) key and increase or decrease the
setting value.
POSITION
Supplement
It will return to AREA parameter screen (1/2)
without changing the settings when you press the
POSITION (
◄
) key (CANCEL).
5
Confirm the setting and press the [ENTER] key (SET).
Setting will be set, and it will return to AREA parameter screen (1/2).
6
Press the [MENU] key.
It will return to default screen.
2