GRAPHTEC FC8600 SERIES - When USER or STANDARD Modes Are Selected; When CUSTOM Mode Is Selected

5-14
5-15
Next page
2
Press the [2] key (ARMS).
ARMS SETTING screen (1/4) is displayed.
3
Press the POSITION (
▼
) key.
POSITION
ARMS SETTING screen (2/4) is displayed.
Supplement
It will return to ARMS setting screen (2/4) without
changing the settings when you press the
POSITION (
◄
) key (CANCEL).
4
Press the [2] key (DISTANCE ADJUST).
DISTANCE ADJUST setting screen is displayed.
5
Press the [1] key (MODE).
DISTANCE ADJUST MODE selection screen is displayed.
Supplement
It will return to MARK DISTANCE screen without
changing the settings when you press the
POSITION (
◄
) key (PREVIOUS).
6
Press the [1] key (USER), the [2] key (CUSTOM), or the [3] key
(STANDARD).
Mode is selected and it will return to DISTANCE ADJUST screen.
7
The procedures are different depending on the selected mode.
When USER or STANDARD modes are selected
Jump to step 9.
When CUSTOM mode is selected
Press the [2] key (CUSTOM UNIT).
CUSTOM UNIT selection screen is displayed.