GRAPHTEC FC8600 SERIES - Replacing the Cross Cut Unit

12-4
12
-
12-5
Supplement
Guideline for replacing cross cut unit.
Paper back film: 1000 mm width media, about
3000 sheets (CT01H)
Plastic back film: 1000 mm width media, about
3000 sheets (CT01H)
l
l
Replace the cross cut unit used to cut off the media after cutting.
Next page
Operation
1
Check that the power switch is turned off (the “
u
” side is
pressed down).
CAUTION
The cross cut unit uses a very sharp blade. Take
care not to cut yourself on the blade.
2
Remove the screw holding the cross cut unit in place, and then
remove the cross cut unit.
Cross cut unit
3
Remove the protective cover from the replacement cross cut
unit. Be sure to remove the protective cover while holding the
part of the unit shown in the figure below.
Protective cover
3
Replacing the Cross Cut Unit