5-11
Setting Registration Mark Size
Preset the size of registration marks to scan.
Size of the registration mark that can be set is from 5 mm to 20 mm.
Bigger registration mark size is better if there is difference in printing or media is set tilted. But the cutting area
becomes smaller with the bigger registration mark.
Feed direction of media
Feed direction of media
When detecting a registration mark, it will start from the lower left registration mark, and search next in
horizontal and vertical directions. If the print is tilted as shown left, short registration marks will be outside the
detection area.
If the registration marks are large like shown right, it can be detected even if the print is tilted.
It will be easier to detect using larger registration size when using a cutting data long in the media feed direction.
Next page
1
Press the [MENU] key.
MENU screen is displayed.
2
Press the [2] key (ARMS).
ARMS SETTING screen (1/4) is displayed.
3
Press the POSITION (
▼
) key.
ARMS SETTING screen (2/4) is displayed.
To Next Page
Loading...
