GRAPHTEC FC8600 SERIES - Setting the Pouncing Tool

14-2 14-3
Setting the Pouncing Tool
Set the distance of the holes when continuous holes are to be punched.
Next page
Operation
1
Press the [CONDITION] key in the default screen.
CONDITION setting screen (1/3) is displayed.
Supplement
It will return to CONDITION screen (1/3) without
changing the settings when you press the
POSITION (
◄
) key (CANCEL).
2
Press the [2] key (TOOL).
TOOL setting screen is displayed.
3
Press the [1] key.
CONDITION No. screen is displayed.
* Display may vary depending on the selected tool condition number.
4
Press the POSITION (
▲▼
) key and select the tool condition
number (CONDITION No.).
POSITION
5
It will get set and return to TOOL setting screen by pressing the
POSITION (
◄
) key (PREVIOUS).
POSITION
CONDITION No. is selected and return to TOOL setting screen.
6
Press the POSITION (
▲▼
) key and select "POUNCE".
POSITION