GRAPHTEC FC8600 SERIES - Tool Offset Adjustment; For between Tool 1 and 2

14-8
14-9
7
Press the [CONDITION] key.
It will return to default screen.
Tool Offset Adjustment
Supplement
This setting is maintained even if the power is
turned off.
This is used when there is difference in cutting between 2 tools.
For between tool 1 and 2
Position adjustment is performed by entering the compensation value if there is a difference between tool 1
(tool attached to the backward of the tool holder) and tool 2 (tool attached to the pen station).
Next page
Operation
CAUTION
When pushing the tool holder with your fingers,
the blade tip may be protruding. Take care not to
cut your fingers.
1
Mount either the cutter plungers or the plotting pens on the tool
1 (backward of the tool holder) and turn on the power.
2
Press the [MENU] key in READY status.
MENU screen is displayed.
3
Press the [1] key (TOOL).
TOOLS SETTING screen (1/3) is displayed.
Supplement
It will return to TOOLS SETTING screen (1/3)
without changing the settings when you press the
POSITION (
◄
) key (CANCEL).
4
Press the [2] key (TOOL OFFSET ADJ.).
POSITION
TOOL OFFSET ADJ. setting screen is displayed.
5
Press the [1] key (TOOL).
TOOL OFFSET ADJ. screen is displayed.