GRAPHTEC FC8600 SERIES - Printing the Setting of the Plotter

13-16
13
-
13-1713-17
Printing the Setting of the Plotter
Condition setting list can be printed when you need to check the current setting of the plotter.
CAUTION
Do not place you hand around the moving areas. The tool carriage will start moving, so there is a chance of injury. Tool carriage will start to move
immediately after selecting to print the CONDITION list.
Next page
Operation
Supplement
See "Loading Media (Paper or Marking Film)"
P.2-6
for loading the media.
1
Set a media larger than A3 size.
Supplement
See "Attaching a Tool"
P.2-4
for setting the
pen tool.
2
Set the pen tool to the tool carriage.
3
Press the [MENU] key.
MENU screen is displayed.
4
Press the POSITION (
◄
) key (TEST).
POSITION
TEST menu screen (1/2) is displayed.
5
Press the [1] key (CONDITION LIST).
CONDITION LIST print screen is displayed.
2