GRAPHTEC FC8600 SERIES - Setting the Separator

4-22
4-23
Supplement
It will return to
MEDIA setting
screen (2/3)
without changing the settings when you press the
POSITION (
◄
) key (CANCEL).
5
Confirm the setting and press the [ENTER] key (SET).
Setting will be set, and it will return to MEDIA setting screen (2/3).
6
Press the [MENU] key.
It will return to default screen.
Setting the Separator
Operation
Supplement
SEPARATOR cannot be set if the AP MODE is off.
1
Turn on the AP MODE by performing the steps 1-6 of "Switching
Apparel Mode"
P.4-20
.
AP MODE is switched on and it will return to AP MODE screen.
2
Press the [3] key (GP-GL) or the [4] key (HP-GL).
SEPARATOR setting screen is displayed.
Supplement
It will cross cut when the command set as a
separator is received.
Separator can be selected from F, JO, H, or FS for
the GP-GL.
Separator can be selected from AF, AH, PG, NR,
SP, IP, SC, IW, PS, DF, or IN for the HP-GL.
"-" is showing that no separator is selected.
3
Press the POSITION (
▲▼
) key and select the SEPARATOR.
POSITION
4
Confirm the setting and press the POSITION (
◄
) key
(PREVIOUS).
POSITION
Separator will be selected and it will return to AP MODE screen.
Supplement
It will return to
MEDIA setting
screen (2/3)
without changing the settings when you press the
POSITION (
◄
) key (CANCEL).
5
Confirm the setting and press the [ENTER] key (SET).
Setting will be set, and it will return to MEDIA setting screen (2/3).
6
Press the [MENU] key.
It will return to default screen.