GRAPHTEC FC8600 SERIES - Reading the Error Message

13-24 13-2513-25
7
Operate switches and sensors following the instructions on the
screen.
"NORMAL" will be displayed if the operation is detected correctly, and next test will start.
It will return to TEST menu screen once all the test items are completed.
Test items are as following.
1
Set lever
sensor
2 Home sensor 3
Push roller
sensor
4
-X media
sensor
5
+X media
sensor
6 X motor signal 7 Y motor signal 8 Tool height signal
9 [1] key 10 [2] key 11 [3] key 12 [4] key
13 POSITION [
►
] key 14 POSITION [
◄
] key 15 POSITION [
▼]
key 16 POSITION [
▲
] key
17 [ENTER] key 18 [CONDITION] key 19 [ORIGIN] key 20 [FAST] key
21 [CROSSCUT] key 22 [COPY] key 23 [MENU] key 24 [STOP] key
Reading the Error Message
Contents of most current 32 errors can be checked. Errors before that are not recorded.
Next page
Operation
1
Press the [MENU] key.
MENU screen is displayed.
2
Press the POSITION (
▼
) key (ADV.).
POSITION
ADVANCE screen (1/3) is displayed.
3
Press the POSITION (
▲
) key.
POSITION
ADVANCE screen (3/3) is displayed.