GRAPHTEC FC8600 SERIES - Setting Timeout

4-20 4-21
Supplement
It will be set to mode for apparel when the
apparel (AP) mode is set on. Use it turned off
for all other cases.
TIME OUT, SEPARATOR, and SPACE REAR
can be set when it is on.
l
l
5
Press the [1] key (AP MODE).
AP MODE switch screen is displayed.
Supplement
It will return to AP MODE screen without changing
the settings when you press the POSITION (
◄
)
key (PREVIOUS).
6
Press the [1] key (ON) or the [2] key (OFF).
AP MODE is selected and it will return to AP MODE screen.
Supplement
It will return to default screen without changing the
settings when you press the POSITION (
◄
) key
(CANCEL).
7
Confirm the setting and press the [ENTER] key (SET).
Setting will be set, and it will return to MEDIA setting screen (2/3).
8
Press [MENU] key.
It will return to default screen.
Setting Timeout
Next page
Operation
Supplement
TIME OUT cannot be set if the AP MODE is off.
1
Turn on the AP MODE by performing the steps 1-6 of "Switching
Apparel Mode"
P.4-20
.
AP MODE is switched on and it will return to AP MODE screen.
2
Press the [2] key (TIME OUT).
TIME OUT setting screen is displayed.
Supplement
Once the cutting is completed, it will
automatically cross cut after time specified
as timeout has past. It will not cross cut
automatically if it is set to "0".
Values that can be set are 0, 1, 2, 3, 5, 10, 20,
30, 60, or 120 seconds.
l
l
3
Press the POSITION (
▲▼
) key and increase or decrease the
setting value.
POSITION
4
Confirm the settings and press the POSITION [
◄
] key
(PREVIOUS).
POSITION
Timeout will be selected and it will return to AP MODE screen.