GRAPHTEC FC8600 SERIES - Connecting to the Computer

1-12
1
-
1-13
4
Connecting to the Computer
Connect the plotter to the computer using the interface cable. Use either the USB port, the network
(LAN) port, or the RS-232C port to connect the plotter to the computer. Select the port depending on the
specification of the software to be used and the availability of the interface port on the computer.
Depending on the port used, use either the USB cable, the network (LAN) cable (sold separately), or the RS-
232C cable (sold separately) to connect. Use the cables specified by Graphtec, matching the computer that
is to be connected.
Next page
Connection
1
Check that the power switch is turned off (the “
u
” side is
pressed down).
Supplement
See the "Setting Interface"
P.9-2
about setting
the interface.
2
Connect the plotter to the computer using the interface cable.
USB cable
(supplied)
Computer
Connection via USB interface
Network (LAN)
cable
(sold separately)
Network
hub
Computer
Connection via LAN interface