7-8
7
-
7-9
It may not cut the curved line smoothly if there is very short lines in the curve.
It will cut in the units of the specified value when the STEP PASS is used, which allows to control the short
lines with certain length, resulting to stable rotation of the blade for higher cut quality.
Setting range of STEP PASS is from 0 to 20.
Actual length of the STEP PASS is the value of the STEP PASS multiplied by the distance set in the "STEP
SIZE".
P.11-5
"Setting the Step Size (STEP SIZE)"
Supplement
STEP PASS setting is maintained even if the power is turned off.
The cut image may not be what you intended if the set value is too large. It is recommended to set to "1" for normal use.
l
l
Next page
1
Press the [MENU] key.
MENU screen is displayed.
2
Press the [1] key (TOOL).
TOOLS SETTING screen (1/3) is displayed.
Supplement
Setting range is from 0 to 20.
3
Press the [3] key (STEP PASS).
STEP PASS setting screen is displayed.
4
Press the POSITION (
▲▼
) key and increase or decrease the
setting value.
Setting the Step Pass
2
To Next Page
Loading...
