GRAPHTEC FC8600 SERIES - Setting of the Cross Cut Force

3-16
3-17
Setting of the Cross Cut Force
This will adjust the blade force when it cross cuts.
Setting range of cross cut force is from 1 to 48. The force will be larger with larger value. It is set to 30 as a
default.
Decrease the value if the media is thin, and increase the value if the media is thick.
Operation
1
Press the [MENU] key.
MENU screen is displayed.
2
Press the [4] key (MEDIA).
MEDIA SETTING screen (1/3) is displayed.
3
Press the POSITION (
▼
) key.
POSITION
MEDIA SETTING screen (2/3) is displayed.
Supplement
Decrease the value of cross cut force if the media
is thin, and increase the value if the media is thick.
· Range of cross cut force values: 1-48
· Default value: 30
4
Press the [2] key (CROSS CUT FORCE).
CROSS CUT FORCE setting screen is displayed.
5
Press the POSITION (
▲▼
) key and increase or decrease the
setting value.
POSITION
Supplement
It will return to MEDIA setting screen (2/3) without
changing the setting values when you press the
POSITION (
◄
) key (CANCEL).
6
Confirm the setting and press the [ENTER] key (SET).
Setting will be set, and it will return to MEDIA setting screen (2/3).
7
Press the [MENU] key.
It will return to default screen.