1-4
1
-
1-5
3
Assembling
Assemble the stand.
The stand is made up of the following parts.
Stand side bar x 2 Base assembly x 2
Center bar x 1
(Enclosure)
Allen wrench
(for M5 screws) x 1
Socket head cap screw
(M5) x 20
Media stocker x 2
(Enclosure)
Stock roller x 2
(Enclosure)
Front Loading and Rear Loading
It is necessary to set the loading settings from the plotter control
panel depending on the attachment direction.
Default factory setup is set as rear loading.
It is recommended to use as rear loading.
If you desire to load the material from the front, it is also possible to
use the front loading.
Use the plotter with enough space behind in this case.
Also, be aware that continuous cutting with cross cut is not
possible.
Supplement
For front loading, change the settings from the
plotter control panel.
P.2-20
To Next Page
Loading...
