GRAPHTEC FC8600 SERIES - Setting Feed Speed for Pre Feed

8-6
8
-
8-7
Automatic pre feed when cut data is received and the speed of media for pre feed in initial feed are set
here.
Set the feed speed to "SLOW" if the media shifts during the pre feed if the media is heavy or slippery. It is
normally set to "NORMAL".
P.2-23
"Pre Feed of Media (Paper or Marking Film)"
P.8-6
"Perform Automatic Pre Feed When Media is Set (Initial Feed)"
P.8-4
"Perform Automatic Pre Feed When Cut Data is Received"
Supplement
Setting for the FEED SPEED for pre feed is maintained even if the power is turned off.
Next page
Operation
1
Press the [MENU] key.
MENU screen is displayed.
2
Press the [4] key (MEDIA).
MEDIA SETTING screen (1/3) is displayed.
3
Press the POSITION (
▼
) key.
POSITION
MEDIA SETTING screen (2/3) is displayed.
4
Press the [1] key (FEED SPEED).
FEED SPEED setting screen is displayed.
Setting Feed Speed for Pre Feed
4