GRAPHTEC FC8600 SERIES - When Media Change Mode Is on

4-12
4-13
Next page
When Media Change mode is on
The Change Media message appears each time when ending a single cut in Media Change mode.
Choosing to change media will instantly detect the media and proceed to a copy area (cut).
Media switch copies can be made up to the set copy number (designated number).
Operation
1
Create one data you want to copy.
Once the cutting operation is finished, remove the media.
Cutting data is stored in the buffer memory.
2
Press the [COPY] key.
COPY MODE screen is displayed.
Supplement
Turning MEDIA CHANGE MODE on will display
the CHANGE MEDIA message each time after
a single cut.
"If the POSITION (
◄
) key (QUIT COPY) is
pressed, copying will be suspended and it will
return to the default screen.
When exchanging media, the media selection
will be chosen from what was selected before
copying.
If there is no data in the buffer memory,
"NO DATA FOR COPY IN BUFFER!" will be
displayed. Please send cutting data.
If too much data is sent from the buffer memory,
"COPY MODE BUFFER FULL!" will be
displayed.
l
l
l
l
3
Press the [1] key (MEDIA CHANGE MODE).
MEDIA CHANGE MODE setting screen is displayed.
4
Press the [2] key (ON).
Confirm the settings and return to the COPY MODE screen.
5
Press the [2] key (NUMBER OF COPIES).
NUMBER OF COPIES setting screen is displayed.
6
Press the POSITION (
▲▼
) key and increase or decrease the
setting value.
POSITION
Supplement
The copy number can be set from 1 to 100.
Supplement
It will return to COPY MODE screen without
changing the settings when you press the
POSITION (
◄
) key (CANCEL).