GRAPHTEC FC8600 SERIES - Page 95

4-12
4-13
13
On the COPY MODE setting screen, press the [3] key (CROSS
CUT).
The CROSS CUT setting screen is displayed.
14
When [1] is pressed, “OFF” is selected. When [2] is pressed,
“ON” is selected.
Press the [ENTER] key to determine the setting or press the [
◄
]
key to cancel the setting.
15
On the COPY MODE setting screen, press the [4] key (CROSS
CUT SPACE).
The CROSS CUT SPACE screen is displayed.
Increase or decrease the setting value with the POSITION (
▲▼
)
keys.
POSITION
Supplement
Digits of settings can be changed by pressing
the [FAST] key.
The settable range is 5.0 mm to 999.0 mm.
l
l
16
Confirm the setting and press the [ENTER] key (SET).
"COPY" is displayed on the screen, and it will copy as much as specified.
Supplement
Cutting data is stored even if the media is
exchanged. It can be copied as many times until
the buffer memory is cleared. It can be copied
again after exchanging the media by pressing
[COPY] key.