4-11
Supplement
Number of copies can be set from 1 to 100, as
much as it can fit in the media set on the printer.
The initial value for the number of copies is
always 1.
l
l
6
Press the [2] key (NUMBER OF COPIES).
NUMBER OF COPIES setting screen is displayed.
7
Press the POSITION (
▲▼
) key and increase or decrease the
setting value.
8
Confirm the setting and press the POSITION (
◄
) key
(PREVIOUS).
Copy space will be selected, and it will return to COPY mode
screen.
9
Press the [3] key (COPY MODE SET). (Setting is enabled only
when the media replacement mode is disabled.)
The COPY MODE setting screen is displayed.
10
Press the [1] key (COPY SPACE X).
The COPY SPACE X setting screen is displayed.
For setting COPY SPACE Y, Press the [2] key in step 10 above.
COPY SPACE Y can be set in the same way as COPY SPACE X.
11
Press the POSITION (
▲▼
) key and increase or decrease the
setting value.
12
Confirm the setting and press the POSITION (
◄
) key
(PREVIOUS).
Copy space will be selected, and it will return to COPY mode
screen.
Supplement
Copy interval can be set when MEDIA CHANGE
MODE is turned off.
Copy space can be set from 1.0 mm to 50.0
mm.
When copying data with registration marks,
copy space should be set more than 20 mm
(0.787”).
This setting is maintained even if the power is
turned off.
l
l
l
l
Supplement
Copy interval can be set when MEDIA CHANGE
MODE is turned off.
Copy space can be set from 1.0 mm to 50.0
mm.
When copying data with registration marks,
copy space should be set more than 20 mm
(0.787”).
This setting is maintained even if the power is
turned off.
l
l
l
l
Supplement
"CANNOT COPY CUT AREA TOO SMALL!" is
displayed if the cutting area is smaller than the
copy data. Either expand the cutting area, or set
the media that is big enough to copy.
Supplement
Cutting data is stored even if the media is
exchanged. It can be copied as many times until
the buffer memory is cleared. It can be copied
again after exchanging the media by pressing
[COPY] key.
Next page
To Next Page
Loading...
