4-10
It will copy in following order when COORDINATE AXES ROTATION is set.
Supplement
For the front loading model, rotate the above
figure 180 degrees.
<For rear loading/sheet>
First copy
Second
copy
Origin point
Copy
space
Copy space
Copy origin point
First cut
Third copy
Fourth
copy
Fifth copy Sixth copy
Next page
1
Create one data you want to copy.
Cutting data is stored in the buffer memory.
2
Press the POSITION (
▲▼◄►
) key and move the tool carriage
to the position to copy.
Supplement
When setting the copy interval, set "MEDIA
CHANGE MODE" to OFF.
"NO DATA FOR COPY IN BUFFER!" is
displayed if there is no data in the buffer
memory. Send the cutting data.
If too much data is sent from the buffer memory,
"COPY MODE BUFFER FULL!" will be
displayed.
If the data to be copied is larger than the
cutting area, "CANNOT COPY CUT AREA TOO
SMALL!" will be displayed.
l
l
l
l
3
Press the [COPY] key.
COPY MODE screen is displayed.
4
Press the [1] key (MEDIA CHANGE MODE).
MEDIA CHANGE MODE setting screen is displayed.
5
Press the [1] key (OFF).
Confirm the settings and return to the COPY MODE scre
To Next Page
Loading...
