5-41
Adjust Manually
Supplement
See "Automatically Adjust"
P.5-39
if you are
moving automatically to registration mark for
scanning.
This section describes the operation to adjust with registration
mark scan by moving to registration mark manually after setting the
ARMS mode and POINTS.
Next page
Supplement
Press the [2] key (ARMS) in the MENU screen if it
is not ARMS setting screen.
1
Press the [2] key (MANUAL READ MARKS) in the ARMS
setting screen.
Following message is displayed.
2
Press the POSITION (
▲▼◄►
) key and move the tool carriage
to the area to start scanning of the registration mark.
Supplement
Left figure is for 4POINTS. Size and position of the
registration scan start area is same for 2POINTS
or 3POINTS.
MARK TYPE 1 MARK TYPE 2
Point
4
Point
2
Point
3
Point 1
(point to make
origin point)
Point 1
(point to make
origin point)
Point
4
Point
2
Point
3
Feed direction of media
Move the tool inside this
area
Move the tool inside this
area
Feed direction of media
Start position of registration mark scan
Supplement
It will return to ARMS setting screen (1/4) without
scanning when you press the [4] key (CANCEL).
3
Confirm the position of the tool, and if it is OK, press the [ENTER]
key.
Registration marks are scanned. Following message is displayed when
completed.
To Next Page
Loading...
