5-42
4
Press the POSITION (
▲▼◄►
) key and move the tool carriage
to the next area to start scanning of the registration mark.
Supplement
Left figure is for 4POINTS. Size and position of the
registration scan start area is same for 2POINTS
or 3POINTS.
MARK TYPE 1 MARK TYPE 2
Point 4 Point 2
Point 3
Point 1
(point to make
origin point)
Point 1
(point to make
origin point)
Feed direction of media
Move the tool inside this
area
Move the tool inside this
area
Point 4 Point 2
Point 3
Feed direction of media
Start position of registration mark scan
Supplement
Repeat steps 4 and 5 if a message prompting to
move to next registration mark is displayed.
Numbers to repeat steps 4 and 5 depends
on the number of the registration marks to be
scanned. Follow the instruction displayed on the
screen.
It will scan and return to ARMS setting screen
(1/4) when the [4] key is pressed.
l
l
l
Supplement
Numbers to repeat steps 4 and 5 depends on
the number of registration marks to be scanned.
Follow the displayed message.
It will return to ARMS setting screen (1/4)
canceling settings and adjustment when you
press the [4] key.
l
l
5
Confirm the position of the tool, and if it is OK, press the [ENTER]
key.
Registration marks are scanned. A message to move to next registration
mark position is displayed once the scanning is completed. Repeat steps 4
and 5 following the message in that case.
DISTANCE entry screen is displayed once the registration mark is scanned.
Supplement
Measured distance is displayed in the top line in
the DISTANCE input screen. Input value (initially
same as measured value) is displayed under
that.
If the input value is not changed, it will assume
that there is no difference between measured
distance and the distance in the data.
Digits of settings can be changed by pressing
the [FAST] key.
l
l
l
6
Press the POSITION (
▲▼
) key and increase or decrease the
setting value.
Supplement
It will return to default screen without changing
the settings when you press the POSITION (
◄
)
key (CANCEL).
Distance input screen for point 3 is displayed if
it is set to 3POINTS or more, so repeat steps 6
and 7 to set.
l
l
7
Confirm the setting and press the [ENTER] key (SET).
Adjustment by scanning the registration mark is completed, and it will return
to default screen.
To Next Page
Loading...
