14-9
Next page
Supplement
It will return to TOOL OFFSET ADJ. screen
without changing the settings when you press the
POSITION (
◄
) key (CANCEL).
6
Press the [2] key (TOOL 1-2).
It is set to adjust between the TOOL 1-2 and return to TOOL
OFFSET ADJ. screen.
7
Press the [2] key (TEST PATTERN).
Tool position move screen is displayed.
Supplement
It will return to TOOL OFFSET ADJ. screen by
pressing the [4] key (CANCEL).
Speed of movement will become faster by
pressing the [FAST] key and POSITION key
simultaneously.
l
l
8
Press the POSITION (
▲▼◄►
) key to move the tool carriage to
the location to draw "+". Move at least 50 mm inside the cutting
are for both X and Y.
Supplement
Tool condition 1 will be used with tool 1.
9
Confirm the position of the tool and press the [ENTER] key.
Tool 1 will plot the "+". Screen prompting to change the tool is
displayed once the plotting is completed.
Supplement
Tool condition 2 will be used with tool 2.
10
Set the plotting pen to the tool 2 (pen station) and press the
[ENTER] key.
Tool 2 will plot the "+" and return to the TOOL OFFSET ADJ.
screen once the plotting is completed.
11
Using the "+" plotted by tool 1, measure the distance to the "+"
plotted by tool 2.
Feed direction of media
Y
X
Y mm
X mm
Tool 1
Tool 2
12
Press the [3] key (X).
X AXIS ALIGNMENT setting screen is displayed.
13
Press the POSITION (
▲▼
) key to increase or decrease the
value to set the difference in X axis direction measured in step
11.
To Next Page
Loading...
