GRAPHTEC FC8600 SERIES - Page 116

5-6 5-7
4POINTS
Feed direction of media Feed direction of media
With more registration marks, precision of matching the printed image and the cutting will increase. But if there
are many registration marks, it will take longer to detect, and the area that can be cut becomes smaller.
1 axis adjustment (2POINT detection)
It will detect the tilt of the printing from 2 registration marks, and cut is performed matching the tilt of the print.
Feed direction of media Feed direction of media
2 axes adjustment (3POINT detection)
It will detect the vertical and horizontal tilts from 3 registration marks, and cut is performed matching the tilt of the
print.
Precision of print and cut position will be higher than the 1 axis adjustment.
Feed direction of media Feed direction of media
4 axes adjustment (4POINT detection)
It will detect the left and right vertical tilts and upper and lower horizontal tilt from 4 registration marks, and cut
is performed matching the tilt of the print.
Precision of print and cut position will be higher than the 2 axes adjustment.
Feed direction of media Feed direction of media
Supplement
Alignment registration mark cannot be used.
Cutting area depends on the MARK DISTANCE
and the settings.
l
l
Supplement
Distance between the registration marks can be
adjusted.
Alignment registration mark can be used.
Cutting area depends on the MARK DISTANCE
and the settings.
l
l
l
Supplement
Distance between the registration marks can be
adjusted.
Alignment registration mark can be used.
Cutting area depends on the MARK DISTANCE
and the settings.
l
l
l
Printable area
Printable area
Printable area