5-19
Supplement
It will return to ARMS setting screen (3/4)
without changing the settings when you press
the POSITION (
◄
) key (CANCEL).
The [2] (DEFAULT) cannot be selected until the
adjustment has been performed.
When the adjustment has been performed, the
following screen is displayed.
It will return to ARMS setting screen (3/4) after
setting the sensor level to default when you
press the [2] key (DEFAULT).
l
l
l
5
Press the [2] key (SENSOR ADJUST).
SENSOR ADJUST screen is displayed.
6
Press the [1] key (SCAN).
Following message is displayed.
Supplement
The tool carriage will move faster when the [FAST]
key is pressed simultaneously with the POSITION
key.
7
Press the POSITION (
▲▼◄►
) key and move the tool carriage
to the area to start scanning of the registration mark.
The start position for the tool carriage is shown below.
Be sure to have Rotate and Mirror disabled and load
the media from the rear for this test.
Y
X
Feed direction of media
Feed direction of media
Y
X
MARK TYPE 1 MARK TYPE 2
Move the tool inside this area Move the tool inside this area
Start position of registration mark scan
Supplement
It will return to SENSOR ADJUST screen
without adjustment when you press the [4] key
(CANCEL).
It may not scan correctly even after the
adjustment depending on the condition of the
media. See "Manual Position Adjust"
P.6-3
if the detection does not complete properly.
l
l
8
Confirm the position of the tool, and if it is OK, press the [ENTER]
key.
Registration mark is scanned, and sensor level is adjusted. It will return to
ARMS setting screen (3/4) once the adjustment is completed.
9
Press the [MENU] key.
It will return to default screen.
To Next Page
Loading...
