GRAPHTEC FC8600 SERIES - Page 162

7-4
7-5
7
Press the [2] key (START).
Overcut length for START setting screen is displayed.
Supplement
Setting range is from 0.0 mm to 0.9 mm.
8
Press the POSITION (
▲▼
) key and increase or decrease the
setting value.
POSITION
9
Confirm the setting value, and press the POSITION (
◄
) key
(PREVIOUS).
It will return to OVERCUT setting screen.
10
Press the [3] key (END).
Overcut length for END setting screen is displayed.
Supplement
Setting range is from 0.0 mm to 0.9 mm.
11
Press the POSITION (
▲▼
) key and increase or decrease the
setting value.
POSITION
12
Confirm the setting value, and press the POSITION (
◄
) key
(PREVIOUS).
POSITION
Length for overcut END is selected and return to OVERCUT
setting screen.
13
Repeat steps 3 to 12 as necessary to set multiple tool
CONDITION No.
Supplement
It will return to CONDITION screen (3/3) without
changing the settings when you press the
POSITION (
◄
) key (CANCEL).
14
Confirm the setting and press the [ENTER] key (SET).
Setting will be set, and it will return to CONDITION screen (3/3).
15
Press the [CONDITION] key.
It will return to default screen.