7-17
Supplement
Value set here will be the cut force for the uncut
part of the perforated lines. Toll will be raised
when set to "UP".
Normally, input the smaller value than the
FORCE for cutting to make it half cutting.
l
l
11
Press the POSITION (
▲▼
) key and set the UP MODE.
12
Confirm the setting, and press the POSITION (
◄
) key
(PREVIOUS).
It will return to UP MODE CUT LINE PATTERN setting screen.
Supplement
If the TYPE No. 0-7 is selected in step 8, CUT L
and UP L is only displayed, and not possible to
change. Skip this step, and proceed.
Range possible to set for the CUT L is 0.1 mm
to 100.0 mm.
Range possible to set for the UP L is 0.1 mm to
10.0 mm.
Digits of settings can be changed by pressing
the [FAST] key.
l
l
l
l
13
If the "USER" is chosen in step 8, press the [3] key (CUT) and
the [4] key (UP) to set the cut length and tool up length. Follow
steps 10 to 12 for this operation.
Supplement
It will return to CONDITION screen (2/3) without
changing the settings when you press the
POSITION (
◄
) key (CANCEL).
14
Confirm the setting and press the [ENTER] key (SET) in the
CUT LINE PATTERN setting screen.
Setting will be set, and it will return to CONDITION screen (2/3).
15
Press the [CONDITION] key.
It will return to the default screen.
To Next Page
Loading...
