GRAPHTEC FC8600 SERIES - Page 239

13-12
13-13
Symptom LCD Display Possible Cause Solution
E04024 Registration mark was not
detected.
Redo the sensor level adjustment.
Change the color of the
registration mark.
Check the media.
Check the print position of the
registration mark.
E04025
Registration mark was not
detected.
Redo the sensor level adjustment.
Change the color of the
registration mark.
Check the media.
Check the print position of the
registration mark.
E04026 The Cut by Segmented
Registration function cannot be
used when rotation is enabled.
Disable the rotation function
before using the Cut by
Segmented Registration function.
E04027 The Cut by Segmented
Registration function cannot be
used when mirror is enabled.
Disable the mirror function before
using the Cut by Segmented
Registration function.
E04028 The buffer is full. The Cut by
Segmented Registration function
cannot be executed.
Reduce the data size.