iii
Safety Precautions
WARNING
Do not use the power cord if it is damaged.
l
Use of a damaged cord may result in electric shock or a
fire hazard due to current leakage.
l
Replace the power cord with a new one.
Unplug the power
cord from the socket
Be careful when handling the cutter blade.
l
Touching the blade with your bare hand may cause injury.
l
Do not touch the cutter blade while cutting is in progress.
Safety Precautions
CAUTION
Do not use or store the plotter in a location
exposed to direct sunlight or the direct draft of an
air conditioner or heater.
l
Such locations may impair the
performance of the plotter.
Do not use the plotter in an excessively dusty or
humid location.
l
Such locations may impair the performance of the plotter.
Do not place any receptacle containing water or
other fluid on top of the plotter.
l
Fluid falling inside the plotter may cause electric shock or
a fire hazard due to current leakage.
Do not use the plotter in a location subject to
excessive mechanical vibration or electrical noise.
l
Such locations may impair the performance of the plotter.
When disconnecting the power cord or interface
cable, do not pull on the cord/cable.
l
Such action will damage the cord/cable, resulting in a fire
hazard or electric shock.
If water or foreign matter enters the plotter,
discontinue use. Turn off the power and unplug the
power cord from the electrical socket.
l
Use of a damaged cord may result in electric shock or a
fire hazard due to current leakage.
l
Contact your sales representative or nearest Graphtec
vendor for repairs.
Unplug the power
cord from the socket
To Next Page
Loading...
