2-27
Supplement
It will return to CONDITION screen without
changing the settings when you press the
POSITION (
◄
) key (CANCEL).
6
Press the POSITION (
▲▼
) key, and set the tool.
Supplement
What is Offset
It will adjust the difference between the tip of the
blade in the plunger and the center of the plunger.
There are standard adjustment values for each
cutter blades. Fine adjustment will be made to that
standard values here. (Adjustment will be made
with standard value as 0.)
It is not necessary to set the offset if "Pen",
"Pouncing", or "Light Pointer" was selected in the
tool settings.
Guideline to Set Offset
Refer to the Cutter Blade Manual.
Guideline to Set Pouncing
Blade
material/tool
Setting range
(intervals)
Setting
value for
OTHER
Pouncing 1
~
99
―
To return to continue the settings of other tool
condition number, return to step 3 by pressing
the [1] key.
l
l
l
l
7
Press the [3] key (OFFSET).
OFFSET setting screen is displayed.
* Display may vary depending on the selected condition number.
8
Press the POSITION (
▲▼
) key and increase or decrease the
setting value.
9
Confirm the setting and press the [ENTER] key (SET).
Setting will be set, and it will return to CONDITION screen (1/3).
10
Press the [CONDITION] key.
It will return to default screen.
To Next Page
Loading...
