6-5
TITRATION MODE
- changes the y-axis scale to either the mV (or pH) readings or the selected derivative
values (of mV or pH). Available only for titrations with equivalence endpoints.
- allows you to save the graph as a bitmap file. Available only when the titration is
finished.
6.2 Stopping a Titration
The titration is terminated when one of the following conditions is met:
• Titration Completed. This is the only mode with valid final result values. The
endpoint was successfully detected. The final results will be displayed.
• Manually Terminated. The current titration terminated by the user before the
endpoint was detected.
• Limits Exceeded. The maximum titrant volume was delivered without reaching the
endpoint. An error message is displayed on the screen.
• Critical Error. A critical error occurred and the titration was stopped. These
errors are typically related to the dosing system. An error message is displayed on
the screen.
• Potential Out of Range. The measured values from the electrode are outside the
potential range. An error message is displayed on the screen.
To Next Page
Loading...
Need help?
General
