Hioki 3390 - Page 121

7.5 Measurement Data Saving
113
89
7
Chapter 7 Data Saving and File Operations
When [Harmonic] is selected for measurement contents to be saved, the output, highest, and lowest
orders can be selected in addition to the items to be saved.
Out order Select the orders for output.
Max order Set the highest order to be output. Settable range is 0 to 100.
This setting must be higher than the lowest order setting.
Min order Set the lowest order to be output. Settable range is 0 to 100.
This setting must be lower than the highest order setting.
Harm src This setting stores the measured frequency of the harmonic sync source.
(Harmonic source)
When [Harmonic] is Selected
All Selects all harmonic orders.
Odd Selects only odd harmonic orders.
Even Selects only even harmonic orders.
Return Returns to previous page.
+1↑/-1↓ Increment or decrement by 1.
+10↑/-10↓ Increment or decrement by 10.
100th Sets to the 100th order.
+1↑/-1↓ Increment or decrement by 1.
+10↑/-10↓ Increment or decrement by 10.
0th Sets the zero order (DC component).