Hioki 3390 - Integration Combined with Timing Control

4.3 Integration Value Observation
59
4
Chapter 4 Viewing Measurement Values
After specifying timer and clock settings, press to cause integration to start and stop at the specified
times. Integration can be controlled by the following three timing methods.
4.3.4 Integration Combined with Timing Control
Manually Controlled
Integration
Press to start integration.
Press again to stop integration.
See "4.3.3 Manual Integration Method"
(p. 57)
Reset
Keep
Integrated value
Start
Time
Stop
Timer-Controlled
Integration
開始 停止 リセット
Timer Setting Value
Automatic stop
Press to start integration.
Integration stops automatically
when the timer expires.
See "Timer-Controlled Integration" (p. 60)
Start ResetStop
Keep
Time
Integrated value
Clock-Controlled
Integration
Press .
Integration starts and stops at the
specified times.
See "Clock-Controlled Integration" (p. 61)
Stop Time
Wait Time Clock-Controlled Time
Start Time
Automatic Start Automatic Stop
Integrated value
Start Reset
Keep
Time
When an interval time is enabled, activating Data or Peak Hold by pressing the HOLD key
causes the display to update at each interval.
Also, when timer or clock control is enabled, the final measurement data is displayed at the
specified stop time.