Network Security > ACL > MAC Rule
Network Security
RM GUI HiSecOS EAGLE20/30
Release
3.0
09/2015
195
Destination MAC
Address
Specifies the destination address of the MAC data packets to which the
device applies the rule.
Possible values:
??:??:??:??:??:??
(default setting)
The device applies the rule to MAC data packets with any destination
address.
Valid MAC address
The device applies the rule to MAC data packets with the specified
destination address.
You use the
?
character as a wild card.
Example
00:11:??:??:??:??
: The device applies the rule to MAC
data packets whose destination address begins with
00:11
.
Valid MAC address/bit mask
The device applies the rule to MAC data packets with the specified
source address. The bit mask allows you to specify the address range
with bit-level accuracy.
Example
00:11:22:33:44:54/FF:FF:FF:FF:FF:FC
: The device
applies the rule to MAC data packets with a destination address in the
range from
00:11:22:33:44:54
to
…:57
.
Ethertype Specifies the Ethertype keyword of the MAC data packets to which the
device applies the rule.
Possible values:
custom
(default setting)
The device applies the value specified in the "Ethertype Custom
Value" column.
appletalk
arp
ibmsna
ipv4
ipv6
ipxold
mplsmcast
mplsucast
netbios
novell
rarp
pppoedisc
ppoesess
ipx-new
profinet
powerlink
ethercat
Parameters Meaning
To Next Page
Loading...