Network Security > ACL > MAC Rule
Network Security
198
RM GUI HiSecOS EAGLE20/30
Release
3.0
09/2015
Buttons
Burst Size Specifies the limit in KByte for the data volume during temporary bursts.
Possible values:
0
(default setting)
No limitation of the data volume.
1..128
If during temporary bursts on the port the data volume exceeds the
value specified, the device discards surplus MAC data packets. The
prerequisite is that you specify in the "Rate Limit" column a value >
0
.
Recommendation:
If the bandwidth is known:
Burst Size = bandwidth x allowed duration of a burst / 8.
If the bandwidth is unknown:
Burst Size = 10 x MTU (Maximum Transmission Unit) of the port.
Hit Count Displays the number of MAC data packets to which the device has applied
the rule.
Possible values:
0..18446744073709551615
Timer Displays when the value in the "Hit Count" column exceeded the
maximum value. At this time, the device has reset the value in the "Hit
Count" column to
0
.
Button Meaning
Set Transfers the changes to the volatile memory (
RAM
) of the device and
applies them to the device. To save the changes in the non-volatile
memory, proceed as follows:
Open the
Basic Settings > Load/Save
dialog.
In the table, highlight the desired configuration profile.
If in the "Selected" column the checkbox is
unmarked
, click the
"Select" button.
Click the "Save" button.
Reload Updates the fields with the values that are saved in the volatile memory
(
RAM
) of the device.
Create Opens the "Create" dialog to add a new entry to the table.
In the "Group Name" field, you specify the name of the Access Control
List to which the rule belongs.
In the "Index" field, you specify the number of the rule within the
Access Control List. If the Access Control List contains multiple rules,
the device processes the rule with the lowest value first.
Remove Removes the highlighted table entry.
↑ Moves the highlighted table entry up one row.
The device allows you to mark and move multiple lines simultaneously.
Parameters Meaning
To Next Page
Loading...